RMS Stator 200 W + Regulator Rectifier + Peakrpm CDI + Ignition Coil + Flywheel Kit (Yamaha)

HO stator + PeakRPM CDI box + regulator rectifier + flywheel + external ignition coil kit.

• Direct replacement to your original unit.
• Plug-and-play, direct fit, easy installation.
• All shipped products are tested.

*All item pictures are accurate; if in doubt, do not hesitate to compare our item to your original part.

High output stator 200 watts

• Highest grade of lamination materials.
• Highest grade of copper winding, resistant to 200 degrees Celsius.
• Pick up pulsar coil included.
• Connector included.
• Rubber grommet included.
• Included adjustable timing plate to advance and retard up to 10 degrees.

AC regulator

• 12-volt regulator used by Baja winners.
• For use with all standard halogen and quartz lights.
• Precise voltage control eliminates light burnout.
• Reduce flickering and dimming.
• Simple installation.
• Works with all other OEM parts.
• Rated at 225 watts.

PeakRPM CDI Box

• Our PeakRPM CDI Box provides the optimal output for your ride.
• Higher grade of electronic components.
• The quality exceeds the OEM equipment.

Improved flywheel rotor magneto

RMSTATOR is offering a replacement flywheel with stronger magnets for your YAMAHA YFZ350 BANSHEE, this flywheel can be used as a direct replacement to the OEM.

We suggest combining it to our 100 or 200 watt stator as it will run the lights better in the lower rpm.

• The quality exceeds the OEM equipment.

External ignition coil

Please note: For solid tip spark plugs, you may reuse your original spark plug caps.

• Highest grade of lamination materials.
• The quality exceeds the OEM equipment.
• Spark plug cap(s) included.

If your old parts are defective, RMStator offer replacement parts of high qualities at a fraction of the cost of genuine parts.

Specifications:

Stator
Dimensions:
Interior diameter: 41 mm
Exterior diameter: 103 mm
Thickness: 14 mm
Length of wire stator to grommet: 90 mm
Length of wire grommet to plug: 380 mm
Length of pickup coil's wire to grommet: 100 mm

Other specifications:
Number of wires: 6
Number of plugs: 3
Number of pins: 6

Wire to wire resistance:
Alternator: black to yellow = 0.2 ohms +/-20%
Pickup: white/red to white/green = 100 ohms +/-20%
Source: red to green = 15 ohms +/-20%

CDI Box
Number of plugs: 2
Number of pins: 8
Height: 25 mm
Length: 85 mm
Width: 71 mm
Fixation holes center to center: 85 mm
Wire length: 120 mm 140 mm

Flywheel
Exterior diameter: 128 mm
Interior diameter: 105 mm
Interior diameter center housing: 21 mm
Exterior diameter center housing: 34 mm
Thickness exterior: 12 mm
Thickness interior: 7 mm

External ignition coil
Bracket center to bracket: 90 mm
Wire length: 590 mm
Primary resistance: 0.4 Ω
Secondary resistance: 6.0KΩ
Damped resistance: 5K
Voltage transfer ratio: 150:1
Insulation resistance: >1000M